Alle varer købt i november og december kan byttes helt frem til 31. januar 2025.
Delivery time: 4-8 workdays.
Butikkens adresse og åbningstid er:
DiscoWorld Møllehaven 9 4040 Jyllinge - vis på kort
Butik og Telefon Tirsdag, Onsdag og Fredag
10.00 til 17.30
Lager og vareudlevering Mandag, tirsdag, onsdag torsdag og fredag
09:00 til 17:30
Har du brug for hjælp eller rådgivning inden du bestiller?
Så ring gerne til vores venlige og kompetente sælger Christian Høegh direkte på hans mobil 20832425, Alle ugens 7 dage fra 09:00 til 20:00
Class AB PA amplifier with limiter, 2 x 500 W RMS (4 ohms), 2 x 375 W RMS (8 ohms)
Stereo-PA-Verstärker mit Limiter, 2 x 500 W / 4 Ohm, 2 x 375 W / 8 Ohm
2 operating modes can be selected (stereo or bridged)
2 level controls
Each channel with LED for activated protective circuit (protect) and output meter with clip LED
Signal inputs via XLR or 6.3mm jack connectors
Speaker outputs via lockable speaker jacks and pairs of screw terminals
Additional Speaker plug for 8-ohm bridge operation
Class AB circuitry
Highly efficient Air flow from front to rear
The device is cooled by temperature-controlled fan
(19) 48.3 cm rack installation 2 U
1 x amplifier, 1 x user manual, 1 x power cord, 4 x foot, 4 x screw
Power supply:
115/230 V AC, 50/60 Hz
Power consumption:
710 W 1/8 power
Output power:
2 x 500 W RMS (4 ohms) 2 x 375 W RMS (8 ohms) 1000 W RMS bridged (8 ohms)
Power connection:
Mains input via IEC connector (M) mounting version power supply cord with safety plug (provided)
Frequency range:
20 - 20000 Hz
S/N ratio:
>95 dB
THD:
<0,5 % at 1 kHz
Cooling:
2 x temperature-controlled fan , Air flow from front to rear
Impedance:
Input: 20 kOhm , bal. Input: 10 kOhm , unbal.
Circuitry:
Class AB
Slew rate:
>20 V/µs
Damping factor:
>350
Control elements:
Power switch, level control per channel, groundlift selector, limiter selector, mode switch (stereo/bridged)
Controls:
Short-circuit; overheat; DC voltage; power on/off transients; softstart
Status LED:
Power, level meter, clip, bridged, protect
Connections:
Input: line via 2 x 3-pin XLR Input: line via 2 x 6.3 mm jack socket (mono) mounting version Output: speaker via 2 x speaker built-in socket (F) Output: Speaker (bridge) via 1 x speaker built-in socket (F) Output: speaker via screw terminal Output: Speaker (bridge) via screw terminal
